my new homemade dog box

[smalltown]

here is my new dog box fits around the wheel wells.

http://i821.photobucket.com/albums/zz13 ... /013-1.jpg

and my little bluetick female

[smalltown]

the sides slide open and closed

[shoot4fur]

Hey that looks nice, but your going to need a few more dogs to fill it up....

[smalltown]

wouldnt mind having one more dog, but parents say i am lucky to have one, so i am just fine with my bbluetick

[Spokerider]

That`s a sturdy looking box.
What did ya use for non skid material on the deck for when rigging?

[smalltown]

after i make my strike rack i am going to put some carpet on top

[white]

nice work man and great picture

[JasonBB]

right on that looks good and so does the pup !!!

[1hogwild]

Not sure about the carpet because it holds moisture and the wood will rut faster.

[livetohunt]

Nice looking box. The top will be fine if you prime it first then put 2-3 coats of good exterior latex paint on it. Also get you some exterior caulking and seal every seam and hole where you put a screw in. Then get you the best marine carpet you can find. Dont get that stuff from Home depot go to a boat supply it will cost more but last 10x longer. As long as you repaint it every 3-4 yrs should last for a while. Nice job

[big saint]

Where ya from smalltown??

[blu_cal]

That's a nice box. Thanks for sharing.

[Montana Wellenstein]

im new on here but try useing a rubber mat for nonskid material look up rubbercal.com it may b a little pricey but its worth it because it wont corrod on you

[Montana Wellenstein]

Go rubbercal.com they have outdoor rubber that might be a little better for a dog box.
Montana