Toy-Box

[Bow-cephus]

Here it is guys, suggestions, comments, critiques; all welcome. This is the third box I've built but the first two were litterallt plywood boxes with holes and a door and this one is just in progress still.

Thanks, Troy

[FullCryHounds]

How tall is it inside? Should be about 22 inches. Taller then that and the dogs will bounce up and smash the top of the box. Keep it a bit lower and they won't bounce around so much going over rough roads. Other then that, it looks good. Keep the holes small enough that small or young dogs can't crawl through.

[Bow-cephus]

Thanks and the inside ended up at 23" and the holes will get smaller still, thanks for the advice!

[outlaw13]

is it just going to be an open box or are you going to divide it and if that is your rig rail it looks a little short but it is hard to tell in pictures also if your that bare in making it you might think of putting some storage for it.

[Bow-cephus]

Hey outlaw, nope the rig rail will come a little later, I've promised myself to only use free materials, I left the posts a little long at first as I did not know how tall I wanted it to be. and storage is a good idea I left room to put a toolbox in front as well.

Troy